The IP addresses should both be set to the IP address of Unified Access Gateway. To require users to authenticate through two authentication methods, change OR to AND in the drop-down.Īdd a new section at the bottom of your INI file. Select the second authentication method from the third drop-down menu.Click the + and select either AND or OR.Select one authentication method from the first drop-down menu.To configure authentication that includes applying a second authentication method if the first authentication attempt fails. Currently, RSA SecurID and RADIUS authentication methods are supported. The authentication methods you configured in Unified Access Gateway are listed in the drop-down menus. The default is to use pass-through authentication of the user name and password. Select the authentication methods to use. To configure the authentication method rule, and other advanced settings, click More.Select IPv4, IPv6, or IPv4+IPv6 from the drop-down menu. To use the Blast Secure Gateway, change NO to YES. The default is the Unified Access Gateway IP address and port 4172. It must contain an IPv4 address and not a hostname. URL used by Horizon clients to establish the Horizon PCoIP session to this Unified Access Gateway appliance. For example, sha1= C3 89 A2 19 DC 7A 48 2B 85 1C 81 EC 5E 8F 6A 3C 33 F2 95 C3.Ĭhange NO to YES to specify whether the PCoIP Secure Gateway is enabled. If you do not provide a list of thumbprints, ensure that the server certificates are issued by a trusted CA. Įnter the list of Horizon server thumbprints. Unified Access Gateway can communicate with servers that use the Horizon XML protocol, such as Horizon Connection Server, Horizon Air, and Horizon Cloud with On-Premises Infrastructure.Įnter the address of the Horizon server or load balancer. Configure the following edge service settings resources for Horizon: Option.In the Horizon Settings page, change NO to YES to enable Horizon.Click the Horizon Settings gearbox icon.In the General Settings > Edge Service Settings, click Show.In the admin UI Configure Manually section, click Select.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |